The light will not come on if you follow a few simple steps. By doing so, you will be able to reset the SRS light. If you want to jump the wire, you can attach one end of the paperclip to each of the two terminals. How do you reset the airbags in a Toyota? Wrap a paperclip around your finger and then fold it in half. The airbag is designed to deploy only once, and then it must be replaced. How Do You Reset The Airbag On A Toyota Corolla?Ĭredit: There is no reset button for the airbag on a Toyota Corolla. The airbag system should now be reset and the codes should be cleared.Ī malfunction in the airbags system, front passenger occupant classification system, or the seatbelt pretensioner system can all be detected by the SRS warning light. Reconnect the negative battery terminal and start the vehicle. With the new fuse in place, reattach the cover to the airbag control module. If the fuse is blown, replace it with a new one. Using a test light or multimeter, check the fuse to see if it is blown. Once you have found the airbag control module, you will need to remove the cover. This is usually located under the driver’s seat. This will help to prevent any accidental airbag deployment while you are working on the vehicle. Start by disconnecting the negative battery terminal. Here is a step-by-step guide on how to flash airbag codes on your Toyota Corolla 1996: 1. The process is actually quite simple and can be done in a few minutes. If you have a Toyota Corolla 1996, you may be wondering how to flash the airbag codes.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |